CF-110VH-2A Features:

· In view of the non - wetting and continuous welding of the PCB substrate with small patch parts and large parts, the bad  phenomena such as continuous welding are improved obviously

· Residual flux is less, and the color of the products nearly transparent, so after soldering is not sticky

· Flux residue is non corrosive, so the electrical welding products excellent insulation performance

· Regardless of the use of foam or spray can form a uniform coating effect

CF-110VH-2A Parameter:

• TAMURAEC-15-7
  
  EC-15-7 is a high performance, low-residue type flux developed for automatic soldering using Pb-free solders and an excellent solderability can be obtained with it in Pb-free soldering.
• TAMURAEC-19S-10
  
  EC-19S-10 is a high performance,mat type flux developed for automatic soldering using Pb-free solders and an excellent solderability can be obtained with it in Pb-free soldering.
• TAMURAEC-19S-A
  
  EC-19S-A Low-residue type Post-flux for printed circuit boards mounted with chip parts for Pb-free soldering.
• TAMURAEC-25
  
  Post-flux for printed circuit boards mounted with chip parts for Pb-free soldering
• TAMURACF-110VMS
  
  CF-110VMS is a high performances, mat type flux developed for automatic soldering of printed circuit boards mounted with chip parts and discreet parts.
• TAMURAULF-210R
  
  ULF-210R is a light-colored, highly heat-resistant, special synthetic resin type ultralow residue flux developed for automated soldering of printed wiring boards mounted with chips general discrets.