HOW TO USE：

1. Optimum tip temperature for refreshing the tip is from 300-360°C.

2. Dip the tip in the Tip Refresher.

3. Apply solder to the tip and then clean completely with the sponge on the soldering iron stand (goot ST series).

4. Apply solder to the tip again. The tip is now tinned and wetting is restored. If the tip is still not wetting properly, repeat steps 2 and 3 above.

• GOOTRX-852AS
  
  Excellent heat recovery is achieved with the combination of a 150W-compact high-output-heater and a high-sensitivity-sensor.Tackles tasks previously impossible without such power.
• GOOTRX-701AS-711AS
  
  With the new sensor integrated into the heater (Patent Pending) a 60W large heat capacity allows faster temperature recovery during heavy soldering, reducing the reaction time even at lower temperature settings.
• GOOTR RD RB Series
  
  R RD RB Series